41NFS2yR9VL.jpg

AntMiner T9 ~11.5TH/s @ 0.126W/GH 16nm ASIC Bitcoin Miner



More Info

$1,399.99

Hash Rate: 11.5TH/s (±7% is expected).
Power Consumption: 1450W (±10%) at the wall (with Bitmain’s APW3 PSU, 93 percent efficiency, 25C ambient temp).
Power Efficiency: 0.126 J/GH at the wall (with Bitmain’s APW3 PSU).
Noise level: Loud. Not for desk-top use. Sounds like a vacuum.
Chip quantity per unit: 171 x BM1387.
Rated Voltage: 11.60 ~13.00V.
Operating Temperature: 0C to 40C.
Network Connection: Ethernet (cable not included).

Notes:
1. Due to the nature of these products, there are higher than normal restocking fees (typically 30-40%). The restocking fees are typically waived in the event that there is a provable failure within the first 30 days. In the event that you experience a failure, please reach out to the seller immediately so that we can begin troubleshooting with you and/or processing a return.
2. Each AntMiner T9 requires TEN 6-pin PCI-e connectors for 12V DC input (must be very stable power source) There are three hash boards that require three 6-pin PCI-e connectors each and one additional 6-pin PCI-e connector on the controller. All TEN 6-pin PCI-e connectors are required. Do not connect more than one PSU to the same hash board to prevent possible damage and instability.
3. Power consumption figures will vary with your PSU’s efficiency, the ambient operating temperature and the accuracy of the power meter.
4. Power supply unit is not included. Bitmain recommends the APW3 or the APW5 power supply for the AntMiner T9.

Check Also

51rcLs496YL.jpg

Bitcoin Embroidered Soft Crown 100% Brushed Cotton Cap – Black

More Info $19.99 High Quality Cap, EMBROIDERED in the USALow Profile, Unstructed CapMade of 100% ...